Connecting The Water Supply - Stihl RB 302 Notice D'emploi

English
Disconnect the high-pressure hose
Release the hose reel brake
N
To release the hose reel brake, pull the
handle (1) downward.
To lock the brake, press the handle (1)
firmly upward until the hose reel is
locked.
Unroll the high-pressure hose (2)
N
Unscrew the union nut (3)
N
Open the hose guide (4)
N
Pull high-pressure hose (2) off of
N
connector
Connecting the high-pressure hose
Push the high-pressure hose (2)
N
onto the connector of the hose reel
Attach union nut (3) and screw it on
N
and tighten by hand
Push the high-pressure hose into
N
the hose guide (4) and close the
hose guide.
Release the brake (1) on the hose
N
reel and wind up the high-pressure
hose
8
High-pressure hose and spray gun
Connection
2
3
1
Push the high-pressure hose (1)
N
onto the connector (2)
Attach union nut (3) and screw it on
N
and tighten by hand
Disconnection
4
3
Push the coupling (4) in the
N
direction of the arrow and hold it
Loosen the union nut (3) and
N
unscrew it from the connector in the
direction of the arrow
High-pressure hose extension
As a rule, always use only one high-
pressure hose extension – see "Special
accessories"

Connecting the water supply

Briefly rinse out the water hose before
connecting it to the machine to prevent
sand and other particles from entering
the machine.
Connect hose (3/4" diameter, length
N
at least 10 m to absorb pressure
surges)
RB 302
RB 402 PLUS
Mesh the jaws of the hose
N
connector (1) and coupling (2) with
each other and turn right as far as
possible
Turn on water supply
N
In suction operation, the machine can
also be connected to rivers, lakes,
cisterns and tanks, etc. – see
"Connecting to a pressureless water
supply".
RB 302, RB 402 PLUS