Stihl RB 302 Notice D'emploi page 8

English
Keep the high-pressure cleaner as far
away as possible from the object being
cleaned. Keep the machine at least 1 m
away from buildings while working.
Your power tool produces
toxic exhaust fumes as
soon as the engine is
running. These gases
may be colorless and
odorless and may contain
unburnt hydrocarbons
and benzene. Never work
with the engine-driven
device in closed or poorly
vented rooms – even not
with devices equipped
with a catalyst.
The machine must not be covered.
Ensure that the engine is cooled
sufficiently.
Ensure proper ventilation when working
in trenches, hollows or other confined
locations – risk of fatal injury from
breathing toxic fumes!
With sick feeling, headache, eye defect
(for example, shrinking field of vision),
hearing impairment, dizziness, fading
powers of concentration, stop working
immediately – such symptoms may be
caused, among others, by high exhaust
gas concentration – risk of accident!
No smoking when working with or near
the machine - risk of fire! The fuel tank
may give off inflammable vapors.
Do not direct the high-pressure jet
against animals.
Do not direct the high-pressure jet onto
places you cannot see.
Children, animals and bystanders must
remain at a distance.
6
Hazardous substances (e. g. asbestos
or oil) must not be allowed to escape into
the environment unchecked when
working with the machine. The
applicable environmental regulations
must be observed without fail.
Surfaces of asbestos cement must
never be cleaned with a high-pressure
jet. Hazardous, breathable asbestos
fibers may be released in addition to the
dirt. The danger is greatest when the
washed surface has dried.
Delicate parts made of rubber, fabric or
similar materials must not be cleaned
with a pencil jet, e. g. from the rotary
nozzle. Maintain a sufficient distance
between the high-pressure hose and the
surface when cleaning to avoid any
damage to the surface being cleaned.
The trigger on the spray gun must move
easily and automatically return to its
starting position when released.
Hold the spray attachment firmly with
both hands in order safely to withstand
the kickback force and additional torque
produced when using spray
attachments with angled spray lance.
Ensure that the high-pressure hose is
not damaged by being driven over,
squashed or pulled; protect it against
heat and oil.
If the machine is subjected to unusually
high loads for which it was not designed
(e. g., heavy impact or a fall), always
check that it is in good condition before
continuing work - refer also to the
chapter "Before starting work". Also
make certain that the safety
mechanisms are working properly.
Never continue using a machine that is
not in perfect working order. In case of
doubt, have the unit checked by your
servicing dealer.
Before leaving the machine unattended:
Shut off the engine.
Safety equipment
When the safety equipment is activated,
excessive pressure is returned to the
intake side of the pump via a safety
valve. This safety feature has been set
by the manufacturer and must not be
adjusted.
After finishing work
Shut off the engine before leaving it
–
Disconnect water intake hose
–
between machine and water supply
Maintenance and repairs
The machine must be serviced regularly.
Do not attempt any maintenance or
repair work not described in the
Instruction Manual. All other work should
be carried out by a servicing dealer.
STIHL recommends that maintenance
and repair work be carried out only by
authorized STIHL dealers. STIHL
dealers receive regular training and are
supplied with technical information.
Use only high-quality replacement parts,
in order to avoid the risk of accidents or
damage to the machine. Contact a
dealer if in doubt.
STIHL recommends the use of genuine
STIHL spare parts. Such parts have
been optimized for the machine and the
user's requirements.
RB 302, RB 402 PLUS