Connecting The Water Supply - Stihl RE 521 Notice D'emploi

Unscrew the union nut (2)
N
Pull high-pressure hose (1) off of
N
connector
Connecting the high-pressure hose
Push the high-pressure hose (1)
N
onto the connector of the hose reel
Attach union nut (2) and screw it on
N
and tighten by hand
Roll up high-pressure hose
N
High-pressure hose and spray gun
Connection
2
3
1
Push the high-pressure hose (1)
N
onto the connector (2)
Attach union nut (3) and screw it on
N
and tighten by hand
RE 521, RE 551 PLUS, RE 581, RE 581 PLUS
Disconnection
4
3
Push the coupling (4) in the
N
direction of the arrow and hold it
Loosen the union nut (3) and
N
unscrew it from the connector in the
direction of the arrow

Connecting the water supply

Briefly rinse out the water hose before
connecting it to the machine to prevent
sand and other particles from entering
the machine.
Connect hose (3/4" diameter)
N
Mesh the jaws with each other and
N
turn right as far as possible
Turn on the tap – water tank fills with
N
water
Do not use dirty water. When the water
quality is poor (e. g., flowing sand), use
a water filter in the water intake – see
"Special accessories".
English
45