Symbols Used; For Your Safety; Target Groups; Intended Use - Mennekes AMEDIO Professional+ 22 Manuel D'utilisation

1.3

Symbols used

The activities marked with this symbol may only
be carried out by a qualified electrician.
This symbol indicates an important note.
The symbol indicates additional,
useful information.
f This symbol is used to point out a call for action.
„ This symbol indicates a listing.
Î This symbol is used to refer to another section in this
manual.

This symbol is used to refer to another document.
9
This symbol is used to point out a result.
2

For your safety

2.1

Target groups

Operator
As the operator, you are responsible for the device.
You are responsible for proper and safe use of the device.
This includes instructing persons who use the device.
As an operator without electrical engineering training, you
are only allowed to execute simple activities that do not
require a qualified electrician.
Qualified electrician
As a qualified electrician you have a recognised
qualification in electrotechnical engineering. On
account of this specialist knowledge, you are
authorised to carry out the required electrotech-
nical tasks described in this manual.
Requirements for qualified electricians:
„ Knowledge of general and special regulations pertain-
ing to safety and accident prevention.
„ Knowledge of electrotechnical regulations.
„ Knowledge of national regulations.
„ Ability to identify risks and avoid potential hazards.

2.2 Intended use

The device is a charging system for use in semi-public
and public areas.
The device is intended exclusively for the charging of
electric vehicles.
„ Charging in accordance with Mode 3, as stipulated in
IEC 61851-1 for vehicles with batteries that do not gen-
erate gas.
„ Plugs and sockets according to IEC 62196.
Vehicles with batteries that generate gas cannot be
charged.
The device is solely intended for fixed floor mounting.
EN
3