1.3
Symbols used
Only a qualified electrician may carry out opera-
tions marked with this symbol.
This symbol indicates an important note.
The symbol indicates additional, useful informa-
tion.
f This symbol marks a prompt for action.
This symbol marks a listing.
Î This symbol is used to refer to another section in this
manual.
This symbol is used to refer to another document.
9
This symbol is used to point out a result.
2. For your safety
2.1
Target groups
Operator
As the operator, you are responsible for the device.
You are responsible for proper and safe use of the device.
This includes instructing persons who use the device.
As an operator without specialist electrical training, you
may only carry out activities that do not require a qualified
electrician.
Electrician
As a qualified electrician, you have received
recognised electrotechnical training. Based on
this knowledge, you are authorised to carry out
the electrical work requested in this manual.
Requirements for qualified electricians:
Knowledge of general and special regulations pertain-
ing to safety and accident prevention.
Knowledge of electrical regulations.
Knowledge of national regulations.
Ability to identify risks and avoid possible hazards.
2.2 Intended use
MENNEKES wall-mounted charging stations are charging
systems designed for use in private and semi- public areas,
e. g. company car parks, depots or private land.
The device is used solely to charge electric vehicles.
Mode 3 charging as per IEC 61851-1.
Mode 1 charging as per IEC 61851-1 (only
Premium* S 22).
Plug designs as per IEC 62196.
The device is intended only for stationary wall mounting.
The device can only be used in a network of several
devices. Several devices are connected via a MENNEKES
ACU. An ACU is installed in the MENNEKES eMobility-
Gateway and in the Smart charging stations. If required, the
ACU can be connected to a backend system, e.g.
chargecloud.
EN
3