Testing The Device; Closing The Device; Operation; Authorisation - Mennekes AMEDIO Professional+ 22 Manuel D'utilisation

6.6 Testing the device

Test according to IEC 60364-6 and the applicable
national regulations (e.g. in Germany: DIN VDE 0100-
600)
Prior to the initial commissioning, execute a test of the
device in accordance with IEC 60364-6 and the appli-
cable national regulations (e.g. DIN VDE 0100-600 in
Germany). The test can be carried out in connection with
the MENNEKES test box and standard-compliant test
equipment. The MENNEKES test box simulates vehicle
communication. Test boxes are available as an accessory
from MENNEKES.
f Perform a standard test before releasing the device.

Operating instructions of the test box.

6.7 Closing the device

T
ATTENTION
Device damage due to crushed components or cables
If components or cables are crushed when closing the
device, damage and malfunctions can occur.
f When closing the device ensure that components or
cables are not crushed.
f If necessary fix components or cables in place.
f Fit the front panel from above into the housing.
f Close the clamping devices.
f Push the cover from the side onto the device.
f Turn key anti-clockwise to close the cover.
f Keep the key out of reach of unauthorised persons.
7

Operation

7.1

Authorisation

Depending on the configuration, using the device may
require prior authorisation. The following possibilities exist:
„ No authorisation is required. All users can charge.
„ Authorisation through RFID.
„ All users with an RFID card can charge.
„ All users whose RFID card is activated can charge.
„ Authorisation through Backend-System
„ Authorisation is dependent on a Backend-system,
for example an RFID card, smartphone app or ad
hoc (e.g. direct payment).
„ For Professional+ PnC 22 (T2S) versions only:
Authorisation through communication between
device and vehicle according to ISO 15118.
Requirement: support your vehicle and Backend-
system (ISO 15118).
9
The symbol "Standby" lights up on the LED information
panel.
f Authorisation dependent on the configuration:
f Authorisation through RFID: Hold the RFID card in
front of the RFID card reader.
f Authorisation through Backend-System: Follow the
instructions for the respective Backend-System.
f Authorisation according to ISO 15118: Connect the
charging cable to the vehicle and the device.
f Comply with the instructions on the device (e.g. scan
QR code).
9
The data are checked. The "Wait time" symbol lights
up on the LED information panel.
9
The authorisation was successful. The charging pro-
cess can now be started.
If charging does not start within the release time,
the authorisation is reset, the charging sockets
are locked and the device switches to "Standby"
mode. A new authorisation is required.
EN
35