Symbols Used; For Your Safety; Target Groups; Intended Use - Mennekes AMTRON Xtra Guide D'installation

1.3

Symbols used

Only a qualified electrician may carry out opera-
tions marked with this symbol.
This symbol indicates an important note.
The symbol indicates additional, useful informa-
tion.
f This symbol marks a prompt for action.
„ This symbol marks a listing.
Î This symbol is used to refer to another section in this
manual.
This symbol is used to refer to another document.

This symbol is used to point out a result.
9

2. For your safety

2.1

Target groups

Electrician
As a qualified electrician, you have received rec-
ognised electrotechnical training. Based on this
knowledge, you are authorised to carry out the
electrotechnical work requested in this manual.
Requirements for qualified electricians:
„ Knowledge of general and special regulations pertain-
ing to safety and accident prevention.
„ Knowledge of electrotechnical regulations.
„ Knowledge of national regulations.
„ Ability to identify risks and avoid possible hazards.

2.2 Intended use

®
The AMTRON is a charging station for use in private and
semi-public areas, such as private property, company car
parks or depots, access to which is limited.
The device is used solely to charge electric vehicles.
„ Mode 3 charging according to IEC 61851-1.
„ Plugs and sockets according to IEC 62196.
The unit is intended for permanent installation and for
indoor and outdoor use.
For Premium versions only: the device can be used as a
single charging point or in a group of several devices with
a back-end system. Several devices are connected via a
MENNEKES ACU. An ACU is installed in the MENNEKES
eMobility-Gateway and in a Smart charging column.
For Xtra versions only: the device can be used as a single
charging point.
EN
3