Communication Protocol; List Of Commands - RADWAG UYA 4Y.PLUS Ultra-Microbalances Manuel De L'utilisateur

39.

COMMUNICATION PROTOCOL

General Information
A. A character based communication protocol (balance-indicator) is designed for establishing
communication between a RADWAG balance and a peripheral device via RS-232C interface.
B. The protocol consists of commands sent from a peripheral device to the balance and
responses from the balance.
C. Responses are sent from the balance each time a command is received.
D. Commands, forming the communication protocol, enable obtaining data on balance status and
facilitate influencing balance operation, e.g.: acquiring measurement results from the balance,
zeroing, etc.

39.1. List of Commands

Command
Z
T
OT
UT
S
SI
SIA
SU
SUI
C1
C0
CU1
CU0
DH
UH
ODH
OUH
SM
TV
RM
NB
PROFILES
PRG
LOGIN
LOGOUT
SS
IC
Command overview
Zero balance
Tare balance
Give tare value
Set tare
Send stable measurement result in basic measuring unit
Immediately send measurement result in basic measuring unit
Immediately send measurement results from all weighing platforms in
basic measuring units
Send stable measurement result in current measuring unit
Immediately send measurement result in current measuring unit
Switch on continuous transmission in basic measuring unit
Switch off continuous transmission in basic measuring unit
Switch on continuous transmission in current measuring unit
Switch off continuous transmission in current measuring unit
Set min checkweighing threshold
Set max checkweighing threshold
Give value of min checkweighing threshold
Give value of max checkweighing threshold
Set mass value of a single item
Set target mass value
Set reference mass value
Give balance serial number
Set balance profile
Give profile name
User logging
User logout
Value release
Internal adjustment performance
- 183 -