RADWAG UYA 4Y.PLUS Ultra-Microbalances Manuel De L'utilisateur page 190

IC1_OK CR LF - command carried out
Operation is disabled for verified balances.
For non-verified balances the command disables internal adjustment until it is enabled via IC0
command or until the balance is turned off. The command does not modify settings specifying
adjustment start.
Enable Automatic Internal Adjustment of the Balance
Format: IC0 CR LF
Response options:
IC0_I CR LF - command understood but not accessible at this moment
IC0_OK CR LF - command carried out
Operation is disabled for verified balances.
Give Balance Serial Number
Format: NB CR LF
Response options:
NB_A_"x" CR LF - command understood, response: serial number
NB_I CR LF - command understood but not accessible at this moment
x - balance serial number (in between inverted commas)
Example:
Command: NB CR LF - return serial number
Response: NB_A_"1234567" - balance serial number: "1234567"
Lock Balance Keypad
Format: K1 CR LF
Response options:
K1_I CR LF - command understood but not accessible at this moment
K1_OK CR LF - command carried out
Command locks the balance keypad (proximity sensors, touch panel) until the moment of turning the
balance off or until sending K0 command.
Unlock Balance Keypad
Format: K0 CR LF
Response options:
K0_I CR LF - command understood but not accessible at this moment
K0_OK CR LF - command carried out
Give Available Working Modes
Command overview:
Command returns accessible working modes.
Format: OMI <CR><LF>
Response options:
OMI <CR><LF>
n_"Mode name" <CR><LF>
:
n_"Mode name" <CR><LF>
OK <CR><LF>
OMI_I <CR><LF>
Mode name - parameter, working mode name, inserted in between inverted comas. The name takes
form given on a particular balance display, it is provided in a currently selected language.
n - parameter, decimal value determining working mode number.
- command carried out, response: accessible working modes
- command understood but not accessible at this moment
- 190 -