Carrera RC Spider Fox Mode D'emploi page 17

7
+
‒
7 8
R
L
9
R
L
Troubleshooting
Problem Cause
Remote control The ON/OFF-power switch is turned "OFF".
does not work.
The batteries have been wrongly inserted.
The batteries do not have enough power.
The helicopter cannot be
The ON/OFF power switch of the controller is set at "OFF".
controlled with the remote
control
The remote control is possibly not correctly frequency bound with the
receiver on the helicopter.
The rotor blades do not rotate. The power switch on the model or the controller is at "OFF"
The rechargeable battery is too weak or has run out of power.
The battery connection on the helicopter is not made.
You have altered the indicated values of menu points T1-4.
The helicopter does not lift. The rotor blades rotate too slowly.
The battery´s power is not sufficient.
During flight, the helicopter
loses speed and height The battery is too weak.
without any obvious reason.
The helicopter lands too Lost of throttle control.
quickly.
Throttle has been pushed down too quickly.
For the latest version of these operating instructions and information on replacement and spare parts available, please visit
Errors and changes excepted
Colours / final design – changes excepted
will fly backward. Use the timmer for
forward-/backward in order to achieve a
stable neutral position and to avoid that
the helicopter flies forward or backward
when hovering without moving the for-
ward-/backward lever.
When shifting the lever for right/left
pitch to the left or right, the helicopter
pitches to the left or to the right and flies
to the left and right respectively. Use
the timmer for right/left pitch in order to
achieve a stable neutral position and to
avoid that the helicopter will fly to the
left or right when hovering without
moving the lever for right-/left pitch
After having made yourself familiar with
the main control functions and having
chosen an appropriate area for flying
the helicopter, you can start the first
flight.
Choosing the flight area
When being prepared for the first flight you should choose a closed room without any
persons or obstacles which is as big as possible. Due to the size and controllability of
the helicopter experienced pilotes may be able to fly the helicopter in relatively small
rooms. For your first flights we strongly recommend to choose a room with a minimum
floor space of 3 x 4 metres and 2.40 metres of height. After having trimmed your heli-
copter for flight and having made yourself familiar with the controlling and its functions
you may start flying in smaller and less open environments.
For more information on our RC-products please visit carrera-rc.com.
Solution
Turn the ON/OFF-power switch "ON".
Check if the batteries have been correctly inserted.
Insert new batteries.
First set the ON/OFF power switch on the helicopter,
then that on the controller to "ON".
Please carry out a frequency bind between the helicopter and the
remote control as described in "frequency bind between model and
remote control".
Turn the ON/OFF-power switch "ON".
Charge the battery (see chapter "Charging the battery").
Make the plugged connection to be found on the helicopter.
Please reset the indicated values of menu points T1-4
to the values of the standard distribution (P.16).
Push the throttle up.
Charge the battery (see chapter "Charging the battery").
Charge the battery (see chapter "Charging the battery").
Push the throttle down slowly.
17
The helicopter may be flown out of
doors, but only on calm days or days
of very little wind.
Please note that in spite of calm con-
ditions near the ground, it can be
very windy a little further from the
ground.
If this advice is disregarded, the heli-
copter may suffer irreparable damage.
carrera-rc.com in the service area.
Technical changes and design-related changes excepted
Pictograms = symbolic photos