Mounting Battery Charger; Charging The Batteries - Invacare Reliant Plus RHL450-1 Instructions D'installation Et D'utilisation

MOUNTING BATTERY CHARGER

(FIGURE 5)
NOTE: Refer to your local regulations concerning
proper mounting procedures.
1. Place the battery charger with mounting bracket on
the wall at the desired position.
2. With a pencil, mark the MIDDLE hole position.
3. Measure down 6-1/2-inches from the pencil mark and
drill one (1) mounting hole.
4. Install the BOTTOM mounting screw until there is an
approximate1/8-inch gap between the screw head
and the wall.
5. Install the battery charger with mounting bracket onto
the bottom mounting screw.
6. Drill the remaining two (2) mounting holes.
7. Install the two (2) remaining mounting screws through
the mounting bracket and into the wall. Tighten securely.
8. Plug the battery charger into the wall electrical outlet.
NOTE: ON LED should illuminate.
Mounting Bracket (STEP 6)
Battery Charger
with Mounting
Bracket (STEP 5)
Mounting
Screws
(STEP 7)
BOTTOM Mounting Screw (STEP 4)
FIGURE 5 - MOUNTING BATTERY CHARGER

CHARGING THE BATTERIES

(FIGURE 6)
NOTE: Invacare recommends the battery be
recharged daily to prolong battery life.
NOTE: An audible alarm will sound (horn will beep)
when battery is low.
1. Lift UP on the handle on the back of the battery.
2. Lift the battery UP and OUT away from the control
box.
OPERATION (CONT.)
Make sure there is an audible click when
mounting battery on the battery charger to con-
firm proper mounting. Otherwise, injury or dam-
age may occur. Refer to FIGURE 6 for correct
mounting.
3. Place the battery on the battery charger as shown
NOTE: The charge LED will illuminate. When charg-
ing is complete, charge LED will stop illuminating.
NOTE: A battery needing to be fully recharged will
take approximately four (4) hours.
4. Lift UP on the handle on the back of the battery.
5. Lift the battery UP and OUT away from the battery
Make sure there is an audible click when mount-
ing battery on the control box to confirm proper
mounting. Otherwise, injury or damage may oc-
cur. Refer to FIGURE 6 for correct mounting.
6. Reinstall the battery onto the control box as shown in
Handle (STEPS 1, 2, 4 and 5)
(STEPS 3 and 6)
11
WARNING
in FIGURE 6. Make sure there is an audible click.
charger.
WARNING
FIGURE 6. Make sure there is an audible click.
Battery
Battery Charger
Control Box
(STEP 6)
Audible Click
FIGURE 6 - CHARGING THE BATTERIES
OPERATION
(STEP 3)
NOTE: The Battery
mounts to the Con-
trol Box and Battery
Charger as shown.
O
P
E
R
A
T
I
O
N