Opening The Device; Installing The Device; Mounting Distances; Wall Mounting - Mennekes AMTRON Xtra Guide D'installation

5.4 Opening the device

1
Fig.: 8. Opening the device
When delivered, the front enclosure part (2) is not attached
with screws. The screws (1) are stored in the enclosed
accessory bag.
f Ensure that the power supply is switched off.
f Remove the upper enclosure part (2).
f Remove screws (3) of front panel and fold down front
panel (4).

5.5 Installing the device

At strong minus temperatures, the device should
be initially stored for 24 hours at room tempera-
ture before installation and commissioning.
12
2
3
3
1
4

5.5.1 Mounting distances

300
Fig.: 9. Mounting distances [mm]
The specified mounting distances are minimum distances
for unrestricted access during operation, maintenance and
repair.

5.5.2 Wall mounting

MENNEKES recommends mounting at an ergo-
nomically sensible height depending on the
height of the body.
Fig.: 10. Drilling dimensions [mm]
f Mark the mounting holes using the supplied drilling jig
or „Fig.: 10. Drilling dimensions".
300 300