Mettler Toledo IND246 Guide D'installation page 42

11. Unscrew the outer portion of the POWERCELL cable gland from the terminal, and disassemble
12. Slide the outer part of the gland down the prepared cable, keeping the outer drain wire outside
13. Slide the plastic grommet down the cable, and fit it into the gland.
14. Unbraid the individual strands of the inner braided shield.
2-22 METTLER TOLEDO IND246 and IND246 POWERCELL Installation Manual
the cable clamp. Set the clamps and screws aside in a safe place.
Figure 2-37: Outer Component of POWERCELL Cable Gland Disassembled
the body. Position the gland against the cut end of the exterior braided armor. Note the
orientation of the gland – the clamping features should be toward the exterior braided armor.
Figure 2-38: Outer Portion of Cable Gland Installed on Cable
Figure 2-39: Plastic Grommet Positioned in Gland
O-ring
Figure 2-40: Inner Shield Unbraided
Outer drain wire
Plastic grommet
64084463 | 02 | 12/2013