Operation - Meister MSE800-1 Traduction Du Manuel D'utilisation Original

5454000-Saebelsaeg_man 03.12.14 08:23 Seite 52
CAUTION! Wear protective
gloves when changing the saw
blade. Risk of cutting and burns.
Remove saw dust from the saw blade
holder (7a). Rotate the lock (7) of the
saw blade holder (7a) as far as it will go
to the right and hold in this position.
Pull saw blade out of saw blade holder
in accordance with Figure 2. Insert the
new saw blade as far as it will go into
the saw blade holder. Release the
lock (7) and check saw blade for firm
seating. Repeat the procedure if
necessary.
The saw blade holder is
designed to accommodate
ordinary accessories with a
holding shaft for sabre saws.
Electronic stroke rate control/stroke
rate pre-selection function
To saw material properly, rotate the
adjusting wheel for stroke rate pre-
selection (3) (Figure 1b) and set a
suitable stroke rate (0–2800 min
the On/Off switch. The adjustment
wheel also serves to implement
continuous adjustments of the stroke
rate during operation.
—
▲
Reducing the stroke rate
▼
Increasing the stroke rate
+
Setting the saw shoe (Figure 3)
CAUTION! Pull the plug before
carrying out any work on the
machine!
Press the locking lever for the saw
shoe (10) down and slide saw shoe (8)
lengthwise to the required position.
Tighten the locking lever again. To adapt
52
or to provide a safe rest for various
materials, the angle of the saw shoe can
also be modified.
Setting the saw position (Figure 5)
CAUTION! Pull the plug before
carrying out any work on the
machine!
The saw can be set to one of three
positions (0°, +/– 90°). To change the
saw position, push the locking button (2)
in the direction of the arrow. Rotate the
handle (1) to bring the saw shoe (8) to
the desired position. Allow the locking
button (2) to engage.
LED work light (Figure 6)
When the plug is in the socket, the LED
work light (9) is lit to provide better
vision and to enable safe work in darker
areas (Figure 6). The LED work light
goes out when the plug is pulled out of
the socket.
-1
) using CAUTION! LED work light! Do
not look directly into the beam
of light, because this may result in
damage to the eyes.
9 – Operation
Switching on
Press the On/Off switch (4).
The saw starts with a low stroke rate.
With stronger pressure on the switch
(4), the stroke rate increases to the
previously set value.
Switch the machine off to change the
stroke rate using the adjusting wheel (3)
(Figure 1b).