Care & Cleaning - SOLIS 824 Mode D'emploi

• The blender will not knead dough or mash potatoes.
• Do not remove the blender jug while the blender is operating. Always make sure
the blender is switched off by pressing the 'Power'
power plug from the power outlet.
• Do not overload the SOLIS Perfect Blender Pro with more than the specified quan-
tity of ingredients (see MAX-mark on jug) doing so could cause the motor to stall.
Once the icon 'OVERLOAD PROTECTION' stops flashing the blender has now
cooled down and you will be able to use the blender as per instructions. At this
point the blender will be in standby mode and you will only need to press the
function/button that you require to start blending again. However if you have
turned the blender off you will need to switch it back on
has stop flashing commence blending as usual.
• Do not place hot or boiling ingredients into the blender jug; allow to cool before
placing into the blender jug.
L
C A R E & C L E A N I N G
D I S A S S E M B L I N G Y O U R B L E N D E R F O R C L E A N I N G
1. Always ensure the blender is off by pressing the 'Power' button on the control
panel. Then unplug the power plug.
2. Remove the blender jug from the motor base by grasping the handle and lift-
ing the jug in an upward direction.
3. Remove the lid and wash as per care and cleaning instructions.
Ensure all parts are clean and completely dry thoroughly before placing
blender jug onto blender base.
C L E A N I N G T H E M O T O R B A S E
Wipe the motor base with a soft, damp cloth then dry thoroughly. Wipe any excess
food particles from the power cord.
Note:
Do not use abrasive scouring pads or cleaners when cleaning the motor
base as they may scratch the surface.
78
button and unplug the
and only if the icon