Installation And Commissioning - Burkert 8030 HT Manuel D'utilisation

Table 1: Dimension H [mm] of the 8030 HT depending
on the DN of sensor-fitting S030 HT
h with sensor-
dn
fitting s030 ht
06 95,5
08 95,5
15 100,5
20 98
25 98
32 102
40 105,5
50 112
32
Fig. 1: Dimensions [mm] of electronic module SE30 HT
English
16
Version with pulse outputs
NPN and PNP, open collector, 700 mA max., frequency
up to 250 Hz, duty cycle 1/2 ±10%
NPN output: 0,2-30 V DC
PNP output: supply voltage
Version with sinus output:
Supply voltage
Frequency up to 500 Hz, about 2,8 mV peak-to-peak/Hz
under a 50 kΩ load
electrical connection
type of connector cable type
Female connector type • shielded, max. 50 m
2508 (supplied), order
• 5 to 8 mm in diameter
code 438811
• wires between 0,25 and
English
18
54
without
1,5 mm in cross section
2
materials
Part Material
Housing PPS, glass fibre reinforced
Male fixed connector PA
Female connector PA / Stainless steel / NBR
type 2508 / screw /
seal
Sensor-fitting refer to the operating instructions of the
S030 HT fitting used.
electrical data
Version with pulse outputs
Supply voltage
Current consumption
Protection against polarity
reversal
Protection against spike
voltages
Protection against short
circuits
7. insTAllATion AnD
commissioninG
safety instructions
danger
risk of injury due to high pressure in the installation.
• Stop the circulation of fluid, cut off the pressure
and drain the pipe before loosening the process
connections.
risk of injury due to high fluid temperatures.
• Use safety gloves to handle the device.
• Stop the circulation of fluid and drain the pipe before
loosening the process connections.
risk of injury due to the nature of the fluid.
• Respect the prevailing regulations on accident pre-
vention and safety relating to the use of hazardous
products.
12-36 V DC, filtered and
regulated
10 mA max.
yes
yes
yes
English
17 17
English
19 19