Attach The Fin To The Stabilizer - Horizon Hobby ARF Hangar 9 Manuel D'utilisation

21. Thread the clevises back on the pushrod.
22. Attach the aileron linkage to the servo arm.
23. Connect the servo to the radio system to center the aileron servo.
Loosen the nuts, then adjust the linkage so the aileron is in the
neutral position. Place a drop of thread lock on the linkage near
the clevises. Tighten the nuts over the thread lock and against the
clevises, then slide the retainers over the forks of the clevises.
 Repeat this section for the remaining aileron servo installation.
EN

ATTACH THE FIN TO THE STABILIZER

1. Use a square and felt-tipped pen to draw a line on the top of the
stabilizer from the front and rear edges of the slot on the top of the
stabilizer.
2. Fit the fi n to the stabilizer. Use a felt-tipped pen to mark the forward
tip of the fi n on the stabilizer.
3. Use a felt-tipped pen to mark the edge of the stabilizer on the
bottom of the fi n where it fi ts into the stabilizer.
4. Use a hobby knife with a new #11 blade to carefully trim the
covering 1/16-inch (1.5mm) below the line drawn on the fi n.
 Use care not to cut into the underlying wood, weakening the fin.
5. Use a hobby knife with a new #11 blade to carefully trim the
covering 1/16-inch (1.5mm) inside the lines drawn on the stabilizer.
 Use care not to cut into the underlying wood, weakening the
stabilizer. Apply a bead of thin CA into the area where the
film was cut away to seal the edge of the covering, as well
as applying thin CA into any possible cut into the wood.
12