Getting Ready To Build - Dremel 3D40 FLEX Traduction De La Notice Originale

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 63

GETTING READY TO BUILD

OBSERVE ALL PROVIDED
WARNING
!
WARNINGS AND SAFETY
INSTRUCTIONS WHEN USING THE DREMEL 3D40
FLEX. Failure to do so may result in fire, equipment
damage, property damage or personal injury.
DO NOT TOUCH THE
WARNING
!
EXTRUDER TIP DURING
OPERATION OR UNTIL IT HAS COOLED DOWN TO
AT LEAST 60°C (140°F). Contact with the extruder tip
during or after operation before tip has cooled may
result in personal injury.
USE ONLY DREMEL FILAMENT.
WARNING
!
Use of filament not authorized by
Dremel may result in equipment and property
damage.
DO NOT PULL THE FILAMENT
WARNING
!
OUT. Doing so may damage the
extruder.
LOADING/CHANGING FILAMENT
1. Start filament load/change process by tapping
"Filament" button on touchscreen. Extruder will
move to front right corner of print area and extruder
tip will begin to heat.
FIG. 1
Open
2. After extruder stops moving, open the 3D40 FLEX
3. If existing filament is loaded, cut existing filament
4. Remove Spool door by rotating it counter clockwise
Spool Holder
Filament
Close
540
Lid for better access to extruder.
near extruder intake and tap "Next" button on
touchscreen.
and remove existing spool if one is present, see
figure1.
Filament Guide Tube
5
6
7

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

3d40flx01 flex

Table des Matières