Getting Ready To Build - Dremel 3D45 Consignes D'utilisation/De Sécurité

DM 2610047405AB 03-18_3D45 3/27/18 9:51 AM Page 23
Observe
warnings
WARNING
instructions when using the Dremel 3D45.
Failure to do so may result in fire, equipment
damage, property damage or personal injury.
Do not touch the extruder
tip or heated build platform
WARNING
during Dremel 3D45 operation or until it
has cooled down to at least 60°C (140°F).
Contact with the extruder tip or build platform
during or after operation before tip and build
plate has cooled may result in personal injury.
Use only DREMEL filament.
Use
WARNING
authorized by Dremel may result in
equipment, property damage, or personal
injury.
Do not adjust extruder
setting to exceed the
WARNING
maximum rated temperature of the
filament type being used. Heating filament
above recommended range can cause
emissions that may result in personal injury.
Do not pull the filament
out. Doing so may damage
CAUTION
the extruder.
FIG. 1
Open

Getting Ready to Build

all provided
and safety
of filament not
Spool
Holder
Filament
Close
LOADING/CHANGING FILAMENT
1. Start filament load/change process by
tapping "Filament" button on touch screen.
Extruder will move to front right corner of
print area and extruder tip will begin to heat.
2. After extruder stops moving, open the
3D45 Lid for better access to extruder.
3. If existing filament is loaded, cut existing
filament near extruder intake and tap the
arrow button on touch screen.
Filament
Guide Tube
23