INITIAL SETUP
The first time you power on your Dremel 3D40 FLEX
you will be prompted to perform an initial setup of
network. Completing this process will give you access
to notifications of firmware updates.
1. To complete initial setup, tap "Yes" when prompted
on the initial setup screen. If you decline this setup
you can always setup network later.
2. If you choose "Yes", 3D40 FLEX will automatically
connect to your ethernet or search for available
wireless networks.
3. Choose your wireless network using the
touchscreen. Use the arrows to scroll through the
list of available wireless networks. When your
wireless network name is highlighted, tap "Accept".
4. Enter your wireless network password and tap
"Accept".
539