Table Of Contents - Dremel 3D40 FLEX Traduction De La Notice Originale

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 63
3D40 FLEX may become damaged. Dremel
3D40 FLEX is intended to operate in temperature
between 16-29° C (60 - 85° F).
p. Do not move or bump Dremel 3D40 FLEX or the
extruder during operation. The object may build
incorrectly.
q. Do not change filament spool unless the
building process is completed, stopped, or
paused. Changing the filament during building will
cancel the object and may damage the extruder.
r.
Do not pull the filament out until instructed
by the touch screen. Doing so may damage the
extruder.
s. Use extra care not to damage the extruder tip
when clearing debris. Dremel 3D40 FLEX will not
work properly with damaged extruder tip and will
require replacement.
t.
Before every build make sure that the build
platform is covered with Dremel specified build
tape. Use of improper build tape may result in
equipment damage and poor object build quality.
u. Be aware of your body position when using
hand tools to remove objects from the build
platform. Sudden tool slip and improper body
position during object removal from the build
platform may result in personal injury.
v. Avoid scratching the build platform when
removing objects. Scratches in the build platform
will result in improper object creation.
w. Do not drop the build platform. Tempered glass
plate may break and result in personal injury.
x. Do not remove tempered glass plate from
plastic holder. Contact with tempered glass plate
edge may result in personal injury.
y. Do not twist or bend the build platform while
removing objects. Tempered glass plate may
separate from plastic holder and result in personal
injury.
z. Dremel is not responsible for structural integrity
or utility of objects created using Dremel 3D40
FLEX. Structural models created by inexperienced
designers may result in property damage and
personal injury.
SERVICE
a. Always unplug Dremel 3D40 FLEX from
its power before performing any service
procedures. Failure to do so may result in
personal injury and equipment damage.
b. Have your Dremel 3D40 FLEX serviced only by
an authorized Dremel service centre using only
Dremel replacement parts. This will ensure that
proper operation and safety of Dremel 3D40 FLEX
is maintained.
c. Use only Dremel approved materials and
components. Use of object materials, or 3D
objects other than Dremel
materials and genuine Dremel
void warranty.
d. Use only Dremel approved filament. Damage
to the product resulting from use of filament other
than Dremel approved filament is not covered
under warranty.
approved object
®
components may
®
525

TABLE OF CONTENTS

General safety warnings ..................................524
Table of contents...............................................525
Used symbols ....................................................526
FCC compliance ...............................................526
3D40 FLEX Resources ......................................527
Glossary of Terms .............................................528
Getting to know your 3D40 FLEX....................529
Introduction ........................................................531
Kit Contents*......................................................531
Touch Screen .....................................................533
Touch Screen Icons ..........................................538
Initial Setup ........................................................539
Getting Ready to Build .....................................540
Initial setup ........................................................542
Building ..............................................................545
Removing Your Object ......................................547
Best Practices ...................................................548
Maintenance .......................................................549
Maintenance and Service .................................551
Open Source Software .....................................552
Warranty .............................................................553

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

3d40flx01 flex

Table des Matières