Meister MSB1100-2 Traduction Du Manuel D'utilisation Original page 48

c Support the power tool well
before use. This power tool gen-
erates a high torque. If the power
tool is not properly supported dur-
ing operation, this may lead to a
loss of control and injuries.
d Hold the power tool on the insu-
lated grip areas when carrying
out work where the power tool
may come into contact with hid-
den power lines or its own con-
nection cable. Contact with a live
cable can also apply voltage to
metal parts and lead to an electric
shock.
2 Safety precautions when using
long drills
a Never work with a speed higher
than the maximum permitted
speed for the drill. When using
with higher speeds, the drill may
bend easily if it is able to rotate
freely without contact with the
workpiece, and result in injuries.
b Always start the drilling process
with a low speed and with the
drill in contact with the work-
piece. When using with higher
speeds, the drill may bend easily if
it is able to rotate freely without
contact with the workpiece, and
result in injuries.
c Do not exert excess pressure
and only place pressure in a lon-
gitudinal direction to the drill.
Drills may bend, and break, as a
result or lead to a loss of control
and to injuries.
48
5452410-Schlagbohrmaschine_man.indd 48 5452410-Schlagbohrmaschine_man.indd 48
6 – Safety instructions relat-
ing specifically to the
equipment
Always use goggles and
hearing protectors.
Wear a dust protection mask
• Before drilling holes in a wall,
check, if necessary using a cable
detector, whether you are at risk
of contacting concealed power,
gas or water lines.
• Only change a drill/chuck when
the power tool is disconnected
from power supply (unplugged)!
• In order to prevent injuries, ensure
that the work piece to be drilled
is secured (e.g. by clamping in a
vice).
• Prevent motor standstill during
operation.
Safety symbols
The symbols on the housing have
the following meanings:
Model name
When using the hammer
drill, wear goggles.
Wear ear defenders when
using the hammer drill.
Wear a dust protection
mask when using the ham-
mer drill.
05.03.20 08:11 05.03.20 08:11