Steba PG 4 Mode D'emploi page 7

English
Connection
Connect only to the AC voltage (e.g. 230 V)
given on the nameplate.
This appliance satisfies the EC guideline No.
89/336 EEC for radio screening.
Description
Fig. 1
a Hinge lever
b Control lamp
c Temperature selector
d Handle with positioning yoke
e Closing slide
f Grill compass:
top line =
middle line =
bottom line =
Caution - Safety Instructions!
● Operate appliance only under supervision.
Keep children away!
● The appliance may not be operated unless the
hot plates are in place.
Be sure that the hot plates are firmly engaged.
● Before turning the plates, let the appliance
cool off, pull out mains plug.
● Do not bend the connection cable or bring it
into contact with hot parts of the appliance.
● Functioning of the appliance makes the hous-
ing and the grill plates hot during operation
- danger of burns!
● After use, pull out the plug immediately, open
the appliance and let it cool off.
● Let appliance cool off before transport.
● Carefully lock top and bottom plate before
transport.
Never immerse appliance in water for clean-
ing.
● This product satisfies the pertinent safety
regulations for electrical appliances.
Repairs on electrical appliances must be per-
formed by trained personnel only.
Considerable dangers can arise for the user
from improper repairs.
Attention! The surface of the device gets
hot - keep children away
average cooking time in
minutes
type of food
rated setting of the
temperature selector
Application possibilities
Contact grilling:
● The plates lies directly on the food to be grilled
Grill toasting:
● Hot plate placed above the food to be grilled.
Party grilling:
● Both hot plates lies horizontally with double
grilling surface.
Baking waffles:
● Turn plates, plates in the same position as
with contact grilling.
Preparation
1. The appliance is delivered in closed condition
(Fig. 1). To open pull the closing slide to the
left side and raise (Fig. 2).
2. Turning and removing the hot plates
To do this bring the item in the party position
(Fig. 9), pull the respective hot plate lock
forward (Fig. 3) and lift up the plate slightly
diagonal.
Re-insert the plate in the same way slightly
diagonal.
The same figures on the top and bottom plate
can be read from the front (Fig. 4). Hot plate
1 (marking on the front) belongs in the bottom
shell, hot plate 2 in the top shell.
Before using for the first time, rinse the hot
plates, dry them and grease slightly.
7