Console (Fig. E-1) - Tunturi T30 Manuel De L'utilisateur

To start the equipment:
- Insert the mains plug into the equipment.
- Insert the mains plug into the wall socket.
- Set the master power switch to the on
position.
To stop the equipment:
- Set the mains power switch to the off
position.
- Remove the mains plug from the wall socket.
- Remove the mains plug from the equipment.
Safety key (Fig F-4)
The equipment is equipped with a safety key
that must be properly inserted into the console
to start the equipment. If you remove the safety
key from the console, the equipment will stop
immediately.
- Insert the safety key into the slot in the
console.
- Make sure that the clip of the safety key is
properly attached to your clothing.
Make sure that the clip is not removed
from your clothing before the safety key is
removed from the console.
Circuit breaker (Fig. D-B)
The equipment is equipped with a circuit
breaker that interrupts the circuit when the
electricity load is above the maximum capacity.
When this occurs, the circuit breaker must be
pressed.
WARNING
• Before pressing the circuit breaker,
remove the mains plug from the
equipment.
If the equipment shuts down, proceed as
follows to restart the equipment:
- Remove the mains plug from the equipment.
- Press the circuit breaker to restart the
equipment.
- Insert the mains plug into the equipment.
NOTE
• Some circuit breakers used in homes are
not rated for high inrush currents that can
occur when a treadmill is first turned on or
even during normal use. If your treadmill
is tripping the circuit breaker (even
though it is the proper current rating and
the treadmill is the only appliance on
the circuit) but the circuit breaker on the
treadmill itself does not trip, you will need
to replace the breaker with a high inrush
type. This is not a warranty defect. This is
a condition we as a manufacture have no
ability to control.
Unfolding and folding the
equipment (fig. F1-F2)
The equipment can be unfolded for use (fig. F1)
and folded for transport and storage (fig. F2).
Refer to the illustrations for the correct way of
unfolding and folding the equipment.
CAUTION
• Before folding the equipment, make sure
that the incline is 0%. If the incline is not
0%, folding will damage the mechanism.
Adjust incline setting (Manual)
- Fold up your treadmill. (Up)
- Take out adjuster pad safety pin.
- Adjust the adjuster pad in desired position.
- Secure the adjuster pad position with the
safety pin.
- Unfold your treadmill. (Down)
NOTE
• Make sure both adjuster-pads are in
same position to avoid your treadmill to
become unstable.

Console (fig. E-1)

CAUTION
• Keep the console away from direct
sunlight.
• Dry the surface of the console when it is
covered with drops of sweat.
• Do not lean on the console.
NOTE
• The console switches to standby mode
when the equipment is not used for 10
minutes.
19
English