Troubleshooting; Transport And Storage - Tunturi T30 Manuel De L'utilisateur

English
To set running belt tracking (fig.
F-5)
A 10 mm Allen wrench is provided to adjust the
rear roller. Make tracking adjustments from the
left side only. Set belt speed at approximately
3 to 5 kph.
Remember, a small adjustment can make a
dramatic difference!
Turn the bolt clockwise to move the belt to the
right. Counterclockwise to move to the left.
Turn the bolt only a 1/4 turn and wait a few
minutes for the belt to adjust itself. Continue to
make 1/4 rotation turns until the belt stabilizes
in the center of the running deck.
The belt may require periodic tracking
adjustment depending on use and walking/
running characteristics. Some users will affect
tracking differently. Expect to make adjustments
as required to center the tread-belt.
Adjustments will become less of a maintenance
concern as the belt is used. Proper belt tracking
is an owner responsibility common with all
treadmills.
NOTE
• Damage to the running belt because of
incorrect running-belt adjustments is not
covered by the products warranty.

Troubleshooting

Despite continuous quality control, defects and
malfunctions caused by individual components
may occur in the equipment. In most cases it's
unnecessary to take the whole device in for
repair, as it's usually sufficient to replace the
defective part.
If the equipment does not function properly
during use, contact your Tunturi dealer
immediately. Always give the model and serial
number of your equipment. Please state also
the nature of the problem, conditions of use
and purchase date.
If you require spare parts, always give the
model, serial number of your equipment and
the spare part number for the part you need.
The spare part list is at the back of this manual.
Use only spare parts mentioned in the spare
part list.
Error codes
If the display shows an error code
(marked with "E"/ "DC" + number), restart the
equipment and check whether the display still
shows the error code. If the display still shows
the error code, immediately contact the dealer.

Transport and storage

WARNING
• Before cleaning and maintenance, remove
the mains plug from the wall socket.
• Carry and move the equipment with at
least two persons.
• Make sure that there are no other persons
or objects under the equipment.
• When folding the folding the equipment,
make sure that you hear the equipment
lock into position to prevent the
equipment from dropping back down.
CAUTION
• Before folding the equipment, make sure
that the incline is 0%. If the incline is not
0%, folding will damage the mechanism.
- Move the equipment as shown (fig. F3).
Move the equipment and carefully put the
equipment down. Place the equipment on
a protective base to prevent damage to the
floor surface. Move the equipment carefully
over uneven surfaces. Do not move the
equipment upstairs using the wheels, but
carry the equipment by the handlebars.
- Store the equipment in the upright position
(fig. F1). Store the equipment in a dry
place with as little temperature variation as
possible.
24