Console (Fig. E-1); Buttons; Explanation Of Display Items - Tunturi Cardio Fit T35 Manuel De L'utilisateur

English
WARNING
• Before pressing the circuit breaker, remove
the mains plug from the equipment.
If the equipment shuts down, proceed as follows
to restart the equipment:
- Remove the mains plug from the equipment.
- Press the circuit breaker to restart the
equipment.
- Insert the mains plug into the equipment.
NOTE
• Some circuit breakers used in homes are
not rated for high inrush currents that can
occur when a treadmill is first turned on or
even during normal use. If your treadmill is
tripping the circuit breaker (even though it is
the proper current rating and the treadmill
is the only appliance on the circuit) but
the circuit breaker on the treadmill itself
does not trip, you will need to replace the
breaker with a high inrush type. This is not a
warranty defect. This is a condition we as a
manufacture have no ability to control.
Unfolding and folding the
equipment (fig. F1-F2)
The equipment can be unfolded for use (fig. F1)
and folded for transport and storage (fig. F2).
Refer to the illustrations for the correct way of
unfolding and folding the equipment.
Adjust incline setting (Manual)
- Fold up your treadmill. (Up)
- Take out adjuster pad safety pin.
- Adjust the adjuster pad in desired position.
- Secure the adjuster pad position with the safety
pin.
- Unfold your treadmill. (Down)
NOTE
• Make sure both adjuster-pads are in same
position to avoid your treadmill to become
unstable.

Console (fig. E-1)

CAUTION
• Keep the console away from direct sunlight.
• Dry the surface of the console when it is
covered with drops of sweat.
• Do not lean on the console.
18
NOTE
• The console switches to standby mode when
the equipment is not used for 10 minutes.

Buttons

Stop
- Stop workout.
Speed +
- Increases the speed (01.0 ~ 16 KM/H).
- Pressing once increases the speed 0,1 kph.
- Pressing and holding for two seconds will
increase the speed faster.
- Scroll programs and change values in
programming mode.
Speed -
- Decreases the speed (01.0 ~ 16 KM/H).
- Pressing once decreases the speed 0,1 kph.
- Pressing and holding for two seconds will
decrease the speed faster.
- Scroll programs and change values in
programming mode.
Mode
- Select program mode
- Confirm setting to enter next step in
programming mode.
Prog
- Select program mode. ( P1~P36, U1~U3, FAT)
Start/ Pause
- Start selected workout, or restart pause workout
when being in pause mode.
- Pause active workout.
Speed hot keys:
Speed Hot Keys are set as: 3, 4, 5, 6, 7, 8, 9, 10.
For example, the speed changes from any speed
to 6 KPH by pressing the
Speed Hot Key 8.

Explanation of display items

Speed
- Shows the actual treadmill speed in workout
mode.
Distance
- Shows the ran distance workout mode.
- Shows the target distance when being in
programming mode.