Hitachi X200 Série Manuel D'utilisation page 275

Le tableau ci-dessous répertorie les registres de maintien des paramètres de profils
principaux du Groupe "B".
Code
foncti
Nom
on
B001 Selection of automatic
restart mode
B002 Allowable
under-voltage power
failure time
B003 Retry wait time before
motor restart
B004 Instantaneous power
failure / under-voltage
trip alarm enable
B005 Number of restarts on
power failure /
under-voltage trip
events
B011 Start freq to be used in
case of freq pull-in
restart
B012 Level of electronic
thermal setting
B212 Level of electronic
thermal setting, 2nd
motor
B013 Electronic thermal
characteristic
B213 Electronic thermal
characteristic, 2nd
motor
Liste des registres de maintien
R/W Description
R/W Select inverter restart method,
Four option codes:
00...Alarm output after trip, no
automatic restart
01...Restart at 0Hz
02...Resume operation after
frequency matching
03...Resume previous freq. after
freq. matching, then
decelerate to stop and
display trip info
R/W The amount of time a power
input under-voltage can occur
without tripping the power
failure alarm. Range is 0.3 to 25
sec. If under-voltage exists
longer than this time, the
inverter trips, even if the restart
mode is selected.
R/W Time delay after under-voltage
condition goes away, before the
inverter runs motor again.
Range is 0.3 to 100 seconds.
R/W Two option codes:
00...Disable
01...Enable
R/W Two option codes:
00...Restart 16 times
01...Always restart
R/W Three option codes:
00...freq at previous shutoff
01...start from max. Hz
02...start from set frequency
R/W Set a level between 20% and
100% for the rated inverter
current.
R/W
R/W Select from three curves, option
codes: *1
00...Reduced torque 1
R/W
01...Constant torque
02... Reduced torque 2
B-31
Données du réseau
Registre. Plage
Résolution
10A5h 0, 1, 2, 3
10A6h 3 to 250 0.1 sec
10A7h 3 to 1000 0.1 sec
10A8h 0, 1
10A9h 0, 1
1170 0, 1, 2
10ADh 2000 to 0.01 %
10000
1527h
10AEh 0, 1, 2
1528h
.
−
−
−
−
−