Assembly Prior To Installation - Jotul SCAN Andersen 10 Manuel D'installation

4.4 Assembly prior to installation

• The product is delivered in a single packing case.
• After unpacking the stove check that the stove is free of any
damage and that the regulating handles works.
• Remove the service box from the burn chamber.
• IMPORTANT!: A sheet of foam plastic is placed between
the baffl e and the exhaust defl ector for protection during
transport. Be sure to remove this before using the fi replace
for the fi rst time.
4.5 Outlet collar
The product has been prepared for a top outlet by the
manufacturer.
Fitting a outlet collar with a top outlet
Fig. 2
1. Attach the loose outlet collar (Fig. 2-1) which is inside the
ash pan to the outlet using the retaining clips and screws
from the service package.
2. Screw the safety fi tting (Fig. 2-2) crosswise in the outlet collar
to prevent damage to the baffl e and exhaust defl ector when
sweeping the chimney.
Fitting an outlet collar with a rear outlet
Fig. 3
1
1. Lift the baffl e (Fig. 3-1) up carefully.
2. Remove the pins (Fig. 3-2).
3. Ease the baffl e out.
1 2
Fig. 4
1. Lift the exhaust defl ector (Fig. 4-1) up carefully.
2. Remove the pins (Fig. 4-2).
3. Ease the exhaust defl ector out.
Fig. 5
1. Unscrew the outer heat shield (Fig. 5-1).
2. Remove the knockout (Fig. 5-2).
Fig. 6
1. Unscrew the inner heat shield (Fig. 6-1).
2. Remove the knockout (Fig. 6-2).
ENGLISH
1
1
35