Installation; Prior To Installation - Jotul F 360 Série Manuel D'installation Et D'utilisation

ENGLISH
Requirements for protection of inflammable
floors in front of the fireplace
The front plate must comply with national laws and regulations.
Contact your local building authorities regarding restrictions and
installation requirements.
3.3 Walls
Distance from the wall of flammable material
The fireplace is authorised for use with an uninsulated flue with
the distances to the wall of flammable material as shown in fig 1.
Minimum distance to wall for Jøtul F 365 and Jøtul F 366 with
outside air connection through an outside wall :
Fig. 1 C
3.4 Ceiling
There must be a minimum distance of 1000 mm to a combustible
ceiling above the fireplace.
8

4.0 Installation

N.B. Check that the fireplace is free of any damage prior to
commencing installation.
The product is heavy! Make sure you have assistance when
erecting and installing the fireplace.

4.1 Prior to installation

1. Standard product supplied in two packages. One with the
fireplace itself and one with optional base in cast-iron/
concrete/glass or pedestal in cast-iron or with three legs.
2. When the product is unpacked, the burn plates, baffle plate,
exhaust deflector, base plate, ash pan and riddling grate are
removed. Also remove the small side burn plates and gasket
for flue pipe which are in the ash pan.
Fig. 3
3. Lift off the top plate with the top grid (fig. 3A) and bowl (fig.3B).
4. Check that the operating handles work (fig. 29 A, B and C).
5. If the rear flue pipe outlet is used, first drill holes (fig. 5 A) in
the cut-out covers for the flue pipe before they are knocked
out with the aid of e.g a ball-pane hammer.
6. Place the wooden block (fig. 5 B) that holds the exhaust
deflectors in position so that the side plates are supported
when the cut-out covers are removed.
7. Spread out the cardboard packaging on the floor. Lay the
stove carefully on its side.