Waring Commercial WFP14SCE Manuel D'utilisation page 10

ASSEMBLy OF CONTINUOUS FEED CHUTE PARTS
• Clean and sanitize the motor base, and wash, rinse, and sanitize the
continuous feed chute, cover, slinger disc, food pusher, food pusher
insert and processing tools prior to initial use.
• Place the base on a counter or table near a 3-prong electrical outlet.
Position it so that you are looking at the front of the unit and can see
the control levers. Be certain that the cord is unplugged and the OFF
lever has been pressed. Do not plug in the cord until the processor is
completely assembled.
• Pick up the continuous feed chute, holding it in both hands with the
chute pointing in the 4 o'clock position. Place the chute on the base,
fitting its center opening over the motor shaft and placing the handle
at the 7 o'clock position.
• Press the chute down so the round lower rim of the chute fits around
the circular platform. Rotate counterclockwise until it clicks in place
and engages rear interlock.
• Place the slinger (or ejector disc) in the bowl, sliding it over the metal
motor shaft until it reaches the bottom of the chute.
• Select the appropriate accessory disc. Follow directions on page 7 to
attach stem to disc.
• After selecting the appropriate disc and attaching stem, pick up the disc
by holding the disc firmly between both hands. Be careful not to grab
the blades or scrape your hands on the shredding/grating nodules.
• Carefully guide the disc stem over the metal shaft so the double flats
on the shaft line up with the matching shape of the disc stem. The disc
should easily drop into place, but if not, gently rotate until you feel
it drop into place. Be sure it is pushed down as far as it will go. Push
on the outside rim only; never touch the cutting blades. Do not put any food in the chute before
placing the accessory disc onto the shaft.
• Place the cover on top of the chute with the locking tab at the left of locking tab on chute. Press
down the cover and rotate the cover counterclockwise until it latches to the tab on the continuous
feed chute. This will prevent the lid from rising up during processing.
• The interlock tab on the cover will slide into the interlock slot and engage the magnetic safety
interlock switch. The interlock switch prevents operation of the machine unless the cover is in the
proper position. With this switch engaged, the food processor will operate if the power is on and
the controls are turned to ON or PULSE.
NEVER ATTEMPT TO START THE FOOD PROCESSOR WITHOUT THE CHUTE AND
COVER LOCKED INTO POSITION.
10