Tristar FR-6923 Mode D'emploi page 11

Please read the instructions for use and refer to the diagrams of the control/heating element before
using the deep fat fryer.

Check that the voltage stated on the type plate of the deep fat fryer corresponds to the mains voltage.

Only connect the deep fat fryer to a wall socket-outlet with earthing contact.

Before using the deep fat fryer for the first time, clean the individual parts thoroughly (see section "Cleaning")

Never immerse the control/heating element in water and do not clean these parts under running water.

Ensure that all parts are completely dry before filling the deep fat fryer with oil or liquid fat.

It is recommended to use frying oil or liquid frying fat. Solid frying fat can also be used. In this case, special care
must be taken to ensure that the fat does not spatter and the heating element overheats (see section "Solid frying
fat " and "Tips")

Never switch on the deep fat fryer if it is not filled with oil or liquid fat.

Only use oil or fat that does not foam and is suitable for frying. This information is shown on the packaging or
label.

The deep fat fryer must be filled with oil or fat between the two marks on the inside of he bowl, Before switching
on the deep fat fryer, always ensure that it is filled with sufficient fat or oil.

A safety thermal cut-out switches off the deep fat fryer in the event of overheating (see section "Safety")
These instructions show the maximum quantities for frying and must not be exceeded (see Table).

Hot steam is released during frying. Keep a safe distance away from the steam.

When the deep fat fryer is in use, it must be kept out of the reach of children. Do not allow the cord to hang over
the edge of a table or work surface on which the deep fat fryer is standing.

After use, set the thermostat to the lowest setting (turn the thermostat fully anticlockwise). Disconnect the mains
plug and allow the oil or fat to cool down. Do not move the deep fat fryer until it and its contents have cooled
down.

Damaged parts must only be replaced by an authorized customer service center.

The warranty will be invalidated in the case of unauthorized repairs.

Please retain these instructions for future reference.