Problems With The Indoor Lighting Receiver; Changing The Fuse - SOMFY 2401073 Manuel D'installation Et D'utilisation

9. PROBLEMS WITH THE INDOOR LIGHTING RECEIVER?

Problem
The indoor lighting receiver indicator light does
not come on.
The indoor lighting receiver cannot be used
after following the procedure step by step.
The bulb connected to the indoor lighting
receiver does not come on or go off after
pressing the corresponding button on the
control point.
The bulb connected to the indoor lighting
receiver comes on after pressing the Down
button on the control point.
The bulb connected to the indoor lighting
receiver goes off after pressing the Up button
on the control point.
The control point switches another bulb on
or off.
For any problems or unresolved questions, please contact the Somfy assistance service on the number given on the back
cover of these instructions.

10. CHANGING THE FUSE

Environment! Do not dispose of the used fuse with household waste, see
paragraph 2.3.
[1]. Switch off the power supply.
[2]. Remove the cover (1) from the indoor lighting receiver:
- Gently remove the cover using a fl at, pointed tool (such as a fl athead
screwdriver) on one of the sides, around the notch.
- Lever it and lift the cover upwards, without using force, to detach the mounting
lugs from the cover.
[3]. Remove the indoor lighting receiver (2) from the frame (or the surface mounting
housing), taking care not to pull the supply cables.
The fuse is located in the removable fuse-holder which shows the fuse part
>
numbers.
Copyright © 2015 Somfy SAS. All rights reserved.
Possible causes
The indoor lighting receiver wiring is
incorrect.
The power supply is off.
The fuse for the indoor lighting
receiver has blown.
The procedure for saving the control
point in the indoor lighting receiver
has failed.
The control point is too far from the
indoor lighting receiver.
The control point battery is flat.
The bulb has blown.
The remote control is being held the
wrong way round.
The control point is mounted the
wrong way round.
There has been a problem when
programming the control point in the indoor
lighting receiver.
Solutions
Switch off the power supply and check the
wiring – see section 5 "Mounting the indoor
lighting receiver".
Restore the mains power supply.
Change the fuse – see section 10 "Changing
the fuse".
Contact the Somfy assistance service.
Bring the indoor lighting receiver closer and try
pressing a button on the control point again. If
it still does not work, replace the control point
battery.
Replace the battery with a battery with the
same specifications – refer to the control point
instructions.
Switch off the power supply and replace the
faulty bulb with a new bulb. Restore the mains
power supply.
Turn the remote control around so that the
indicator light is below the Up/my/Down
buttons.
Disassemble the control point and refit it the
other way round.
Contact the Somfy assistance service.
1
2
Indoor lighting receiver
12