Programming The Control Point; Identifying The Control Point; One-Touch Point - SOMFY 2401073 Manuel D'installation Et D'utilisation

Indoor lighting receiver
[9]. Fit the indoor lighting receiver (2) into the bracket (5).
- Position the indoor lighting receiver so that "PROG" can be read.
- Ensure that no pressure is exerted on the wires when the indoor lighting receiver
is inserted in its bracket.
- Press the indoor lighting receiver until it clicks; this means that the indoor lighting
receiver has been fi tted correctly on the bracket.
[10]. Follow the steps described in section 6 "Programming the control point" before fi tting
the cover.

6. PROGRAMMING THE CONTROL POINT

To commission the indoor lighting receiver, an RTS control point must be recorded in the indoor lighting receiver.
This control point is used to switch bulbs connected to the indoor lighting receiver on or off.
N.B.: These instructions only describe the installation procedure for an "individual control" type indoor lighting
receiver. Refer to the instructions for advanced functions available on the Internet (address on the back cover of
these instructions) to install a "group control" or a "multiple control".
6.1 Accessing the PROG button on the indoor lighting receiver
The PROG button (A) is located near the word "PROG", above the indicator light (B) and
is shaped like a tab.

6.2 Identifying the control point

Identify the control point in the list below and refer to the section indicated to program the
control point in the indoor lighting receiver:
1) Control point fi xed to the wall with a single button, called a One-touch point, see
paragraph 6.3;
2) Control point fi xed to the wall with Up/STOP/Down buttons, called a Point with Up/
STOP/Down buttons, see paragraph 6.4;
3) Programmer type control point, called a Timer, see paragraph 6.5;
4a) Telis 1 RTS remote control, see paragraph 6.6;
4b) Telis Soliris RTS remote control, see paragraph 6.6;
5a) Telis 4 RTS remote control, see paragraph 6.7;
5b) Telis 4 Soliris RTS remote control, see paragraph 6.7;

6.3 One-touch point

6.3.1 Identifying the model
[1]. Check that the control point has an elongated button only.
[2]. Remove the front cover from the one-touch point:
One-touch point with a white and grey front cover:
[1]. Gently remove the front cover with a fl at, pointed tool (such as a fl athead
screwdriver) where the white section and the grey section join.
[2]. Lever it and lift the cover, without using force, to detach the mounting lugs from
the front cover.
5
5
2
A
B
1
2
3
4a
4b 5a 5b
Copyright © 2015 Somfy SAS. All rights reserved.