Telis 1 Rts/Telis Soliris Rts Remote Controls - SOMFY 2401073 Manuel D'installation Et D'utilisation

Indoor lighting receiver
[5]. Refi t the control point front cover:
- Insert the front cover on its bracket, allowing the buttons to come through
their housings.
- Press the front until it clicks, to fi x the front cover in its bracket.
[6]. Fit the cover (1) on the indoor lighting receiver:
- Place the cover onto the indoor lighting receiver so that the Somfy logo can
be seen in the bottom right-hand side.
- Press on the cover until a click is heard: the cover is correctly fi tted onto the
indoor lighting receiver.

6.6 Telis 1 RTS/Telis Soliris RTS remote controls

The Telis 1 RTS has 1 indicator light (4a) and the Telis Soliris RTS has 2 indicator lights
(4b).
If the remote control has more than 2 indicator lights, refer to the section "Telis 4 RTS/
Telis 4 Soliris RTS remote controls".
6.6.1 Accessing the PROG button on the Telis
Turn the Telis over:
The PROG button (e) is located on the rear panel.
>
6.6.2 Programming the control point in the indoor lighting receiver
[1]. Restore the mains power supply.
[2]. Press and hold the PROG button (A) on the indoor lighting receiver:
The indicator light (B) comes on.
>
The lamp connected to the indoor lighting receiver comes on and then goes off.
>
The indoor lighting receiver PROG function is activated for approximately
>
2 minutes.
[3]. Press the PROG button (e) on the Telis briefl y with the tip of a pencil:
The indicator light for the indoor lighting receiver (B) fl ashes.
>
The lamp connected to the indoor lighting receiver comes on and then goes off.
>
The control point is saved in the indoor lighting receiver.
>
[4]. Press the Up button on the Telis:
- If the lamp corresponding to the indoor lighting receiver comes on, the indoor
lighting receiver is operational.
- If the lamp corresponding to the indoor lighting receiver does not come on,
contact the Somfy assistance service.
[5]. Fit the cover (1) on the indoor lighting receiver:
- Place the cover onto the indoor lighting receiver so that the Somfy logo can
be seen in the bottom right-hand side.
- Press on the cover until a click is heard: the cover is correctly fi tted onto the
indoor lighting receiver.
9
1
1
4a
4b
e
{
e
{
PROG
1
1
Copyright © 2015 Somfy SAS. All rights reserved.