Tools Required; The Indoor Lighting Receiver In Detail; Components; Technical Data - SOMFY 2401073 Manuel D'installation Et D'utilisation

Indoor lighting receiver

3.2 Tools required

Appropriate screwdriver for the screws to be used
•
Insulated fl athead electrician's screwdriver
•
Drill and drill bit
•
Pencil
•

4. THE INDOOR LIGHTING RECEIVER IN DETAIL

4.1 Components

A. PROG button
B. Indicator light
C. Manual On/Off control button
D. Fuse
E. Electrical connection terminal.

4.2 Technical data

Dimensions in mm (H x w x d): 80 x 80 x 45 mm
Operating temperature: + 5°C to + 40°C
Index protection rating: Inside use, in a dry room - IP 30
Frequency: 433.42 MHz
Range: 20 m through two concrete walls; 200 m in open space
Power supply: 230 V; 50 Hz
Fuse: 3.15 A
Power: 500 W max.

5. MOUNTING THE INDOOR LIGHTING RECEIVER

5.1 Before mounting the indoor lighting receiver

5.1.1 Distances
Minimum distance to be kept between an indoor lighting receiver and the ground: (e.g. 150 cm between any RTS control
•
points and/or between any control point and any motor).
Minimum distance to be kept between an indoor lighting receiver and another RTS component: (e.g. 30 cm between any
•
RTS control points and/or between any control point and any motor).
Minimum distance to be kept between two indoor lighting receivers: (e.g. 20 cm between any RTS control points and/or
•
between any control point and any motor).
5.1.2 Conditions
Attention: Do not attach the indoor lighting receiver to a metal surface.
The indoor lighting receiver is only to be installed indoors.
•
Mount the indoor lighting receiver in a housing for recessed mounting which is 60 mm in diameter (minimum depth: 40
•
mm) or in a Somfy housing for surface mounting (not supplied).
Always leave the indoor lighting receiver's front panel clearly accessible; never place anything in front.
•
Check the radio range after the indoor lighting receiver has been mounted. The radio range is limited by the radio
•
appliance control standards.

5.2 Recessed mounting

Somfy recommends fi tting the indoor lighting receiver in place of the original switch.
[1]. Check that the bulbs work.
[2]. Switch off the power supply (fuse removed or circuit breaker off).
[3]. Remove the original switch to access the housing for recessed mounting.
[4]. Screw the mounting bracket (5) onto the housing using the screws supplied.
Attention: If the screws provided are lost, do not use roundhead screws. Only use fl athead screws with a diameter of 3 mm.
3
A
B
C
E
D
5
Copyright © 2015 Somfy SAS. All rights reserved.