SOMFY 2401073 Manuel D'installation Et D'utilisation page 42

Indoor lighting receiver
[4]. Remove the removable fuse-holder using a fl athead screwdriver:
- Gently remove the removable fuse-holder using a fl at, pointed tool (such as
a fl athead screwdriver) around the notch on the edge of the rounded side.
- Gently lever it to detach the mounting lug on the other side of the removable
fuse-holder.
[5]. Remove the fuse from the fuse-holder by pushing it out of the retaining bracket.
[6]. Insert a fuse of the same specifi cations.
[7]. Refi t the fuse-holder on the indoor lighting receiver:
- Insert the mounting lug in its notch.
- Slide the other end into the notch.
- Press on the rounded end until the fuse-holder clicks into the indoor lighting
receiver.
[8]. Make sure that power supply cables are always connected:
Otherwise refi t the wires in the corresponding terminals - see section 5
>
"Mounting the indoor lighting receiver".
[9]. Fit the indoor lighting receiver (2) into the bracket (5).
- Position the indoor lighting receiver so that "PROG" can be read.
- Press the indoor lighting receiver until it clicks; this means that the indoor
lighting receiver has been fi tted correctly on the bracket.
[10]. Restore the mains power supply.
[11]. Check that the fuse works correctly:
[12]. Press the manual control button for the indoor lighting receiver (C).
- If the lamp corresponding to the indoor lighting receiver does not come on,
see section 9 "Problems with the indoor lighting receiver?".
- If the lamp connected to the indoor lighting receiver lights up, then the new
fuse is correct.
[13]. Refi t the cover (1) on the indoor lighting receiver:
- Place the cover onto the indoor lighting receiver so that the Somfy logo can
be seen in the bottom right-hand side.
- Press on the cover until a click is heard: the cover is correctly fi tted onto the
indoor lighting receiver.
13
Section 9
OK
1
1
Copyright © 2015 Somfy SAS. All rights reserved.