Timer - SOMFY 2401073 Manuel D'installation Et D'utilisation

[3]. Quickly press the PROG button (b) on the control point:
The indicator light for the indoor lighting receiver (B) fl ashes.
>
The lamp connected to the indoor lighting receiver comes on and then goes off.
>
The control point is saved in the indoor lighting receiver.
>
[4]. Press the "Up" switch at the control point:
- If the lamp corresponding to the indoor lighting receiver comes on, the indoor
lighting receiver is operational.
- If the lamp corresponding to the indoor lighting receiver does not come on,
contact the Somfy assistance service.
[5]. Refi t the control point front cover:
- Insert the mounting lugs into their notches on one side of the front cover.
- Press on the other side until it clicks, to fi x the front cover in its bracket.
[6]. Fit the cover (1) on the indoor lighting receiver:
- Place the cover onto the indoor lighting receiver so that the Somfy logo can
be seen in the bottom right-hand side.
- Press on the cover until a click is heard: the cover is correctly fi tted onto the
indoor lighting receiver.

6.5 Timer

6.5.1 Checking the compatibility
[1]. Make sure that the mains power supply is off.
[2]. Remove the front cover:
- Lever it with a fl at, pointed tool (such as a fl athead screwdriver), without using
force, around the upper section of the front cover to detach it from its bracket.
The PROG button is located on top of the screen and is shaped like a
>
tab (c).
Attention! If after removing the front cover, no PROG button is found, this means
that the control point is not compatible: It cannot be programmed in the indoor
lighting receiver.
6.5.2 Programming the control point in the indoor lighting receiver
[1]. Restore the mains power supply.
[2]. Press and hold the PROG button (A) on the indoor lighting receiver:
The indicator light (B) comes on.
>
The lamp connected to the indoor lighting receiver comes on and then goes off.
>
The indoor lighting receiver PROG function is activated for approximately
>
2 minutes.
[3]. Quickly press the tab (c) on the control point:
The indicator light for the indoor lighting receiver (B) fl ashes.
>
The lamp connected to the indoor lighting receiver comes on and then goes off.
>
The control point is saved in the indoor lighting receiver.
>
[4]. Press the "Up" button on the control point:
- If the lamp corresponding to the indoor lighting receiver comes on, the indoor
lighting receiver is operational.
- If the lamp corresponding to the indoor lighting receiver does not come on,
contact the Somfy assistance service.
Copyright © 2015 Somfy SAS. All rights reserved.
Indoor lighting receiver
b
{
PROG
1
1
{
c
{
PROG
c
8