Telis 4 Rts/Telis 4 Soliris Rts Remote Controls; Replacing A Lost Or Broken Control Point - SOMFY 2401073 Manuel D'installation Et D'utilisation

6.7 Telis 4 RTS/Telis 4 Soliris RTS remote controls

The Telis 4 RTS (6a) and Telis 4 Soliris RTS (6b) have 4 indicator lights.
6.7.1 Accessing the PROG button on the Telis
[1]. On the Telis, select the channel which will control the lamp connected to the indoor
lighting receiver with the button (f).
[2]. Turn the Telis over:
The PROG button (g) is located on the rear panel.
>
6.7.2 Programming the control point in the indoor lighting receiver
[1]. Restore the mains power supply.
[2]. Press and hold the PROG button (A) on the indoor lighting receiver:
The indicator light (B) comes on.
>
The lamp connected to the indoor lighting receiver comes on and then goes off.
>
The indoor lighting receiver PROG function is activated for approximately
>
2 minutes.
[3]. On the Telis, select the channel which will control the lamp connected to the indoor
lighting receiver with the button (f).
[4]. Press the PROG button (g) on the Telis briefl y with the tip of a pencil:
The indicator light for the indoor lighting receiver (B) fl ashes.
>
The lamp connected to the indoor lighting receiver comes on and then goes off.
>
The control point is saved in the indoor lighting receiver.
>
[5]. Press the Up button on the Telis:
- If the lamp corresponding to the indoor lighting receiver comes on, the indoor
lighting receiver is operational.
- If the lamp corresponding to the indoor lighting receiver does not come on,
contact the Somfy assistance service.
[6]. Fit the cover (1) on the indoor lighting receiver:
- Place the cover onto the indoor lighting receiver so that the Somfy logo can
be seen in the bottom right-hand side.
- Press on the cover until a click is heard: the cover is correctly fi tted onto the
indoor lighting receiver.

7. REPLACING A LOST OR BROKEN CONTROL POINT

If the control point programmed in the indoor lighting receiver is lost or broken, another RTS control point must be programmed
in order to switch the bulb connected to the indoor lighting receiver on and off.
Attention: no more than 12 control points can be recorded in an indoor lighting receiver.
Take another control point which is compatible with the indoor lighting receiver.
•
Follow the steps described in the section
•
control point model.
Attention: If after following this operation, the indicator light (B) on the indoor lighting receiver does not come on,
contact Somfy assistance service for advice on replacement.
Copyright © 2015 Somfy SAS. All rights reserved.
"Programming the control point in the indoor lighting receiver"
Indoor lighting receiver
6a
6b
f
g
{
g
f
{
PROG
1
1
according to the
10