Point With Up/Stop/Down Buttons - SOMFY 2401073 Manuel D'installation Et D'utilisation

Indoor lighting receiver
Model B:
[1]. Restore the electric power supply.
[2]. Press and hold the PROG button (A) on the indoor lighting receiver:
The indicator light (B) comes on.
>
The lamp connected to the indoor lighting receiver comes on and then goes off.
>
The indoor lighting receiver PROG function is activated for approximately
>
2 minutes.
[3]. Take the one-touch control point.
[4]. Remove the battery from the one-touch control point using a plastic object.
[5]. Press on the centre section of the one-touch point button.
[6]. Refi t the battery in the base of its bracket (with text legible).
[7]. Press the one-touch point button again:
The indicator light for the indoor lighting receiver (B) fl ashes.
>
The lamp connected to the indoor lighting receiver comes on and then goes off.
>
The control point is saved in the indoor lighting receiver.
>
[8]. Press the one-touch control point button:
- If the lamp corresponding to the indoor lighting receiver comes on, the indoor
lighting receiver is operational.
- If the lamp corresponding to the indoor lighting receiver does not come on,
contact the Somfy assistance service.
[9]. Fit the cover (1) on the indoor lighting receiver:
- Place the cover onto the indoor lighting receiver so that the Somfy logo can
be seen in the bottom right-hand side.
- Press on the cover until a click is heard: the cover is correctly fi tted onto the
indoor lighting receiver.
[10]. Refi t the control point front cover:
One-touch point with a white and grey front cover:
•
- Insert the mounting lugs into their notches on one side of the front cover.
- Press on the other side until it clicks, to fi x the front cover in its bracket.
One-touch point with a white front cover:
•
- Refi t the front cover on its bracket

6.4 Point with Up/STOP/Down buttons

6.4.1 Checking the compatibility
[1]. Make sure that the mains power supply is off.
[2]. Remove the front cover from the control point:
- Gently remove the front cover with a fl at, pointed tool (such as a fl athead
screwdriver) where the white section and the grey section join.
- Lever it and lift the cover, without using force, to detach the mounting lugs
from the front cover.
[3]. Turn the front cover over:
The PROG button is located next to the battery (b).
>
Attention! If after removing the front cover, no PROG button is found, this means
that the control point is not compatible: It cannot be programmed in the indoor
lighting receiver.
6.4.2 Programming the control point in the indoor lighting receiver
[1]. Restore the mains power supply.
[2]. Press and hold the PROG button (A) on the indoor lighting receiver:
The indicator light (B) comes on.
>
The lamp connected to the indoor lighting receiver comes on and then goes off.
>
The indoor lighting receiver PROG function is activated for approximately
>
2 minutes.
7
{
{
PROG
1
1
b
{
Copyright © 2015 Somfy SAS. All rights reserved.