Installation; Installation Recommendations; Fitting The Slim Io Receiver Rs + Plug; Wiring - SOMFY SLIM IO RECEIVER RS+PLUG Notice

Slim io Receiver RS + Plug

2. INSTALLATION

2.1. INSTALLATION RECOMMENDATIONS

• Minimum distance (X) between a Slim io Receiver
RS + Plug and the ground:
X = 150 cm
• Minimum distance (Y) between a Slim io Receiver
RS + Plug and a radio control point:
Y = 30 cm
• Minimum distance (Z) between two Slim io Receiver
RS + Plug units:
Z = 20 cm

2.2. FITTING THE SLIM IO RECEIVER RS + PLUG

Warning
Comply with current standards and legislation when installing.
Attention
The Slim io Receiver RS + Plug must be installed, protected from rain and in clement weather
conditions, out of sight and out of the reach of children.
1) Turn off the power supply.
2) Disconnect the motor cable quick connection (A) from the
power supply cable quick connection (B).
3) Connect the Slim io Receiver RS + Plug between the motor
cable (A) and the power supply cable (B).
• Motor = motor side (A)
• Supply 230 V = power supply side (B)
4) Lock the securing hooks (C).
Attention
Ensure that the two quick connections are engaged correctly.
5) Place the Slim io Receiver RS + Plug in the awning bracket to
conceal it.
6) Fit the Slim io Receiver RS + Plug (using rilsan cables for example).

3. WIRING

Attention
• Cables routed through a metal internal wall must be protected and insulated by sleeving or
sheathing.
• Secure the cables to prevent any contact with moving parts.
• If the receiver is used outdoors and if the power supply cable is of the H05-VVF type, run the
cable in a UV-resistant duct, e.g. trunking.
• Leave the receiver power supply cable accessible: it must be easily replaceable.
Warning
Always make a loop in the power supply cable to prevent water from entering the receiver.
Copyright © 2017 SOMFY ACTIVITE SA, Société Anonyme.. All rights reserved.
EN
Z
Y
X
OFF
A
A
B
B
C
23