Dismounting/Mounting The Invacare Alegio Tm - Invacare Alegio Manuel D'utilisation

Adjust all mattress support sections to a horizontal position before transporting an assembled bed.
Hold the top of the bed end with both hands while the bed is pushed/pulled.
Only personnel who have been trained or instructed by Invacare
manual in the chapters 12 and 13.
If the functions of the bed change, check the bed according to chapter 13.
The Invacare must be stored in a room with a humidity of 10 - 80%, RH within a temperature of < 0 - 50°C.
Alegio
® TM
4. Dismounting/mounting the Invacare
Dismounting the Invacare
1. Brake the bed and bring it to its lowest position and then about 5 cm up.
2. Remove the accessories: Siderails, bed ends and lifting pole.
3. Dismount the finger screws at both sides (see illustration A).
4. Dismount the cable from the backrest/leg section (see illustration B).
5. Dismount the top frame at the head end and place it in a vertical position (see illustration C and D).
6. Lift the leg section and dismount the pipe pins (see illustration E).
7. Dismount the top frame at the foot end and place it in a vertical position (see illustration F).
8. Dismount the shear arm (see illustration G, H, I, J and K).
Alegio
® TM
may perform the service work described in this
®
Alegio
®
A)
Finger screw
B)
12
TM