Stihl MSA 160 C Notice D'emploi page 91

Specifications
Battery
Type: Lithium-ion
Category: AP, AR
The machine may be operated only with
original STIHL rechargeable batteries.
Running time is dependent on the
energy content of the battery.
Chain Lubrication
Fully automatic speed-controlled oil
pump with reciprocating piston
Oil tank capacity: 210 cc (0.21 l)
Weight
without cutting attachment, without
battery
MSA 160 C: 2.7 kg
MSA 200 C: 2.9 kg
Cutting Attachment
Actual cutting length may be less than
the specified length
Rollomatic E Mini 1/4" Picco guide bars
Cutting length: 25, 30, 35 cm
Pitch: 1/4" P (6.35 mm)
Groove width: 1.1 mm
Nose sprocket: 8-tooth
MSA 160 C, MSA 200 C
1/4" Picco chain
Picco Micro 3 (71 PM3) Type 3670
Pitch: 1/4" P (6.35 mm)
Drive link gauge: 1.1 mm
Chain sprocket
MSA 160 C: 6-tooth for 1/4" P
MSA 200 C: 7-tooth for 1/4" P
Noise and Vibration Data
Noise and vibration data are determined
on the basis of the rated maximum
speed.
For further details on compliance with
Vibration Directive 2002/44/EC see
www.stihl.com/vib/
Sound pressure level L to
p
EN 60745-2-13
MSE 160 C-BQ 84 dB(A)
MSE 200 C-BQ 84 dB(A)
Sound power level L to EN 60745-2-13
w
MSA 160 C-BQ 95 dB(A)
MSA 200 C-BQ 95 dB(A)
Vibration measurement a
hv
EN 60745-2-13
Handle,
left
2
MSA 160 C-BQ 2.7 m/s
2
MSA 200 C-BQ 4.6 m/s
The K-factor in accordance with
Directive 2006/42/EC is 2.5 dB(A) for
the sound pressure level and sound
power level; the K-factor in accordance
with Directive 2006/42/EC is 2.0 m/s
for the vibration measurement.
The vibration values quoted above have
been measured according to a
standardized test procedure and may be
used to compare electric power tools.
Depending on the type of usage, the
vibrations that actually occur may differ
from the values quoted.
The vibration values quoted may be
used for an initial assessment of the
user's exposure to vibrations.
The actual exposure to vibrations has to
be evaluated. This process may also
take into account times during which the
electric power tool is switched off and
times during which it is switched on but
running without load.
Transport
STIHL batteries fulfill the requirements
stated in UN-Manual
ST/SG/AC.10/11/Rev.5 Part III,
Subsection 38.3.
The user can transport STIHL batteries
by road transport to the place where the
machine is to be used without additional
to
requirements.
The lithium ion batteries included are
Handle,
subject to the provisions of the
right
legislation relating to dangerous goods.
2
2.9 m/s
When shipped by a third party (e. g. air
2
3.9 m/s
transport or haulage firm), special
packaging and identification
requirements must be observed.
English
2
89