Checking And Replacing The Chain Sprocket - Stihl MSA 160 C Notice D'emploi

Storing the Battery
Take the battery out of the power
N
tool or the charger.
Store indoors in a dry and safe
N
location. Keep out of the reach of
children and other unauthorized
persons and protected from
contamination.
Do not store spare batteries unused
N
– use in rotation.
To optimize the life of the battery, store
it at a state of charge of about 30%.
Storing the Charger
Remove the battery.
N
Disconnect the plug from the wall
N
outlet.
Store the charger indoors in a dry
N
and secure location. Keep out of the
reach of children and other
unauthorized persons and
protected from contamination.
MSA 160 C, MSA 200 C
Checking and Replacing the
Chain Sprocket
Remove chain sprocket cover, saw
N
chain and guide bar
Release chain brake – set hand
N
guard to ‚
Fitting new chain sprocket
after use of two saw chains or
–
earlier
if the wear marks (arrows) are
–
deeper than 0.5 mm – otherwise the
service life of the saw chain is
reduced – use check gauge (special
accessory) to test
Using two saw chains in alternation
helps preserve the chain sprocket.
STIHL recommends use of original
STIHL chain sprockets in order to
ensure optimal functioning of the chain
brake.
3
1
2
Use a screwdriver to remove the E-
N
clip (1)
Remove the washer (2)
N
Remove chain sprocket (3)
N
2
1
3
Fit new chain sprocket – make
N
certain that the guide pins of the
worm (arrows) line up with the
openings provided on the chain
sprocket and push on the chain
sprocket as far as it will go
Install washer (2) and E-clip (1)
N
English
81