Güde 2T Traduction Du Mode D'emploi D'origine page 10

Inspections and Maintenance Schedule
Time Description
Interval
As needed •
Clean the unit and grease the moving parts
Troubles – Causes - Troubleshooting
Trouble Cause
•
Drain valve not closed properly.
•
Too little hydraulic oil in the system.
Vehicle lifting
•
Air in the hydraulic system.
jack will not lift
•
Valves not closed or contaminated.
or will not lift the
specific load.
The lifting jack • Drain valve not closed properly.
will lower under
• Valves not closed or contaminated.
the weight of the
load.
Oil will escape •
Too much oil in the system
from the oil
screw.
•
Too little hydraulic oil in the system.
Insufficient
•
Valves not closed or contaminated.
pressure at
pumping
Lifting lever will •
Valves not closed or contaminated.
move up and
down under the
weight of the
load
Vehicle lifting
• Too little hydraulic oil in the system.
jack unable to
• Air in the hydraulic system.
reach the full
height
Service
Any technical questions? Complaint? Do you need spare parts or operation manual?
Go to our website www.guede.com and the section Service will help you quickly and without bureaucracy. Please, help us to help
you. In order to identify your device in case of complaint, please indicate serial number, order number and year of manufacture. All
information is available on the product label. To have all information always at hand, put them down.
Serial number:
Order number:
Year of manufacture:
Phone: +49 (0) 79 04 / 700-360
Fax: +49 (0) 79 04 / 700-51999
E-Mail: support@ts.guede.com
Important information for the customer
Please be sure to know that returning the product in or after the warranty period must be made in the original packaging.
Other Details if Necessary
Troubleshooting
•
Close the drain valve by turning the lifting lever to the right.
•
Replenish the hydraulic oil according to the description in the
manual.
•
De-aerate the system according to the description in the manual.
• To rinse the valves, push the piston and close the drain valve
quickly. Lift the drain valve with hand and push and push the
piston down as fast as possible.
• Close he drain valve by turning the lifting lever to the right
• To rinse the valves, push the piston down and close the drain
valve. Lift the piston several times by hand, open the drain valve
and push the piston down as fast as possible.
•
Drain the required amount of oil from the filler hole. Mind the
regulations for the oil disposal.
•
Pour the hydraulic oil in the filler hole.
•
To rinse the valves, push the piston down and close the drain
valve. Lift the piston with hand several times, close the drain
valve and push the piston down as fast as possible.
•
To rinse the valves, push the piston down and close the drain
valve. Lift the piston with hand several times, close the drain
valve and push the piston down as fast as possible.
• Pour the hydraulic oil in the filler hole.
• Open the drain valve, pump the lifting lever several times. Close
the drain valve, Repeat the procedure if necessary.