Operation; Dismantling - Parkside PTBS 30 A1 Mode D'emploi

♦ Clamp the wide distributor
tubes w into the long hose
holders 0 and push the hose
holders 0 into the ground.
♦ Clamp the narrow distributor
tubes q into the short hose
holders 9 and push the hose
holders 9 into the ground.

Operation

♦ Turn on the water tap. The base
appliance 1 regulates the
water pressure.
NOTE
The base appliance 1 has an
►
opening on one side through
which air is released if the wa-
ter pressure is too high. Make
sure that this opening is never
obstructed.
PTBS 30 A1
Adjust the shut-off valve 7
♦
(turn anticlockwise to open/
clockwise to close).
♦ Turn off the tap when you are
finished watering.

Dismantling

Unscrew the base appliance 1
♦
anticlockwise from the tap. If
you are using a garden hose,
push the front part of the coupler
back and pull off the base ap-
pliance 1.
♦ Push all of the distributor
tubes q/w out of the hose
holders 9/0.
Pull the hose holders 9/0
♦
out of the ground.
♦ Dismantle the distributor
tubes q/w from all parts.
GB │ IE │
7 ■