Residual Risks; Operation; Inserting/Replacing The Tool; Set The Direction Of Rotation - Parkside PDSSE 450 C3 Traduction Des Instructions D'origine

GB IE
c) Avoid contact with the tool insert
or the component part immedi-
ately after processing. The parts
may be hot and cause burn injuries.
d) Immediately switch off the
power tool if the tool insert is
blocked due to overloading or
tilting of the component part.
The loss of control can result in injuries.
e) The device must only be connected to
a mains socket via a residual-current
circuit breaker (RCD) with a rated leak-
age current of not more than 30 mA.
f) If the tool's mains power cable
is damaged, it must be replaced
with a particular power lead,
which may be obtained from the
manufacturer or their customer
service representative.

Residual risks

Even if properly operating and handling this
electric tool, some residual risks will remain.
Due to its construction and build, this elec-
tric tool may present the following hazards:
a) Injuries caused by moving parts or hot
surfaces.
b) Ear damage if working without ear
protection.
c) Damage to your health caused by
swinging your hands and arms when
operating the appliance for longer pe-
riods of time or if the unit is not held or
maintained properly.
Warning! During operation, this
electric tool generates an electro-
magnetic ield which, under certain
circumstances, may impair the
functionality of active or passive
medical implants. To reduce the risk
of serious or lethal injuries, we
20
All manuals and user guides at all-guides.com
recommend that persons with medi-
cal implants consult their doctor
and the manufacturer of their medi-
cal implant before operating the
machine.

Operation

Inserting/replacing the tool

1. Push the desired bit (11-14) onto
the tool holder (1).
2. To remove it, pull the bit off from
the tool holder (1).

Set the direction of rotation

You can toggle between right and left rota-
tion by pushing the direction of rotation
switch (5).
The direction changed may only be
performed in standstill mode!
1. Clockwise direction: Push the
directional switch (5) to the right
up to the stop.
2. Counter-clockwise direction: Push
the directional switch (5) to the
left up to the stop.
In clockwise rotation, the maximum
torque is limited to 100 Nm.

Switching on/off

Make sure that the power supply
voltage matches the voltage rat-
ing indicated on the device's type
plate.
Connect the machine to the power
supply..