Connection And Assembly - Parkside PTBS 30 A1 Mode D'emploi

■ Use this product only in con-
junction with the base appli-
ance 1.
■ Make sure that no dirt particles
can clog the connections or get
inside the hose.
■ Make sure all the connections
are firmly attached.
■ After using the product, always
close the water outlet (tap)!
■ Dismantle the product during
cold weather to avoid frost
damage.

Connection and assembly

NOTE
► You can connect the base
appliance 1 to a water tap
or to the coupler of a garden
hose. The arrow symbol on
the base appliance 1 indi-
cates the flow direction of the
water.
The wide distributor tube w
►
is laid from the base appli-
ance 1 to the vicinity of the
desired irrigation point. The
narrow distributor tube q is
laid from the wide distributor
tube w, directly past your
plants, which are watered by
the inline drippers 8.
│ GB │ IE
■ 4
NOTE
► Before assembly, take a look
at the example connection
diagram on the fold-out page.
The following description is
based on this example.
Garden hose connection
Connect the base appliance 1
♦
to the connector of your
garden hose.
Tap connection
♦ Unscrew the garden hose
section anticlockwise from
the base appliance 1.
Screw the base appliance 1
♦
clockwise onto a water tap.
PTBS 30 A1