Maintenance And Care - HOLZMANN MASCHINEN TS 250F Mode D'emploi

Work only with a well cut saw blade.
 Use the push stick at the end of cutting when the distance between the saw blade and the par-
allel ruler is less than 120 mm.
 Make sure that the machine is working without vibrations.
 Cracked and deformed panel saw blades can not be repaired. You need to be sorted out imme-
diately as a committee and be replaced by ordinary.
 Then the panel saw blade must be removed from service.
 Select the number of teeth of the panel saw blade such that at least 2-3 teeth work simultane-
ously). If only one tooth works, a poor working surface results, the risk the vibrations and the
noise exposure increases before setback increase.
14

MAINTENANCE AND CARE

Don't clean or do maintenance on the machine while it is still connected to the
power supply:
Damages to machine and injuries might occur due to unintended switching on of the
machine!
Therefore: Switch the machine off and disconnect it from the power supply before
any maintenance works or cleaning is carried out
The machine is low maintenance and contains little parts that must undergo a maintenance oper-
ator.
Faults or defects that may affect the safety of the machine, must be rectified immediately.
Repair work may only be performed by qualified personnel!
The complete and utter cleaning ensures a long life for the machine and represents a safety re-
quirement.
After each shift the machine and all its parts must be thoroughly cleaned by the dust and swarf
sucked through the suction system and all other waste is disposed of by compressed air.
Check regularly that all warning and safety instructions on the machine and available in a per-
fectly legible condition.
Check before every use the perfect condition of the safety devices.
For storage of this machine may not be stored in a humid room and must be protected from the
influence of weather conditions.
The elimination of defects does your dealer
Repair work may only be performed by qualified personnel!
HOLZMANN MASCHINEN GmbH
A T T E N T I O N
www.holzmann-maschinen.at
MAINTENANCE AND CARE
53
TS 250F