Maintenance; Inspection And Maintenance Plan; Saw Blade Replacement - HOLZMANN MASCHINEN BS712TURN Mode D'emploi

16 CLEANING
Wrong cleaning agents can attack the varnish of the machine. Do not use solvents,
nitro thinners, or other cleaning agents that could damage the machine's paint.
Observe the information and instructions of the cleaning agent manufacturer!
Prepare the surfaces and lubricate the bare machine parts with an acid-free lubricating oil.
Regular cleaning is a prerequisite for the safe operation of the machine and its long service life.
Therefore, clean the device after each use of chips and dirt particles.
17

MAINTENANCE

Danger due to electrical voltage! Handling the machine with the power supply up
may result in serious injury or death. Always disconnect the machine from the power
supply before servicing or maintenance work and secure it against unintentional
restart!
The machine is low-maintenance and only a few parts have to be serviced. Nevertheless, any
faults or defects which may affect the safety of the user must be rectified immediately!
 Before each start-up, make sure that the safety devices are in perfect condition and
function properly.
 Check all connections for tightness at least once a week.
 Regularly check that the warning and safety labels on the machine are in perfect and
legible condition.
 Use only proper and suitable tools.
 Only use original spare parts recommended by the manufacturer.

17.1 Inspection and Maintenance Plan

The type and degree of machine wear depends to a large extent on the operating conditions. The
following intervals apply when the machine is used within the specified limits:
Interval
After work
After every 50
operating hours
After every 100
operating hours

17.2 Saw blade replacement

HOLZMANN MASCHINEN GmbH
NOTICE
WARNING
component
machine
coolant
Moving parts
Gear box
www.holzmann-maschinen.at
Action
 Clean the machine from chips;
 lubricate plank metal surfaces with a
thin layer of oil
 Release tensino of the saw blade
 Lubricate the sliding surfaces of the vice
and the saw blade guide with light
machine oil.
Exchange coolant
lubricate with a thin layer of lubricating oil
or grease
Oil-exchange
 bring the saw arm to its uppermost
position, fix it and close the hydraulic
control.
 Remove the rear protective cover of the
saw arm. To do this, loosen and remove
all screws.
 Loosen the saw blade completely with
the handwheel.
CLEANING
37
BS 712TURN; BS712TURN-G