Sawing; Maintenance; Maintenance Plan - HOLZMANN MASCHINEN BS 115 Mode D'emploi

15.4.10

Sawing

 Turn on the machine with the ON / OFF switch (9).
 Remove the positioning knob.
 The automatic feed to the saw arm moves automatically
downwards.
 Do not apply pressure.
 The saw automatically switches itself off after cutting the material
by triggering the off switch button.
 Pull the saw arm into the air, and insert the positioning knob back in the hole.
THE TEETH OF THE SAW BLADE SHOULD GIVE THE MATERIAL TO BE CUT ALSO BE
ADJUSTED:
1. The thinner / narrower the workpiece, the higher teeth
2. Basic rule: it should be working at any given time at least 3 teeth in the material
NOTE: If the metal band saw a long time is not used, you can relax the saw band with the
adjustment of band tightening (10)
16

MAINTENANCE

Perform all maintenance machine settings with the
machine being disconnected from the power supply!
Serious injury due to unintentional or automatic
activation of the machine!
The machine does not require extensive maintenance. If malfunctions and defects occur, let it be
serviced by trained persons only:
Clean your machine regularly after every usage – it prolongs the machines lifespan and is a
pre-requisite for a safe working environment.
Repair jobs shall be performed by respectively trained professionals only!
Check regularly the condition of the security stickers. Replace them if required.
Check regularly the condition of the machine!
Store the machine in a closed, dry location.
Before first operation you should lubricate all connecting parts.

16.1 Maintenance plan

After each workshift:
 Raise the saw arm in the most upper position, secure it and close the hydraulic flow regulation
valve.
 Detension the saw band.
 Clean the machine entirely.
 Lubricate the gliding surface of the vice and the blade slightly with some machinery oil.
After 50 hours of operation
 Lubricate all connecting parts (if required, remove beforehand with a brush all swarfs and
dust)
HOLZMANN MASCHINEN GmbH
ATTENTION
NOTICE
www.holzmann-maschinen.at
MAINTENANCE
Positioning
knob
BS115 / BS128HDR
54